Injection and compression moulded components are used in a variety of fuel & air systems applications that operate over a diverse temperature range.

Potable and waste water system components are also included within our product range.

Injection moulded components have the advantage of offering lower costs and reduced weight.

The following assemblies use plastic injection moulded components:

Jet Pumps
Valves
Sensors
Indicators
Fuel Caps and Adaptors

Dependent on the particular application and selective use of these Engineering Thermoplastics a temperature range between -55°C & +260°C can be accommodated.

Chemical, fuel & corrosive resistance of some of the high performance range of thermoplastics are better than aluminium alloys.

The materials used are Compression Thermoset materials and Engineering Thermoplastics, some of which have been compounded specifically for particular applications.